Help reconnecting HD Homerun to network

[loucille48]

I had to replace my main TV, however, since I disconnected the HD Homerun box from my old TV, I cannot get it to reconnect to my network.

I have changed out the ethernet cord. Unplugged the power cord and plugged back in. Changed the port where my Homerun box is connected to my router. Nothing works.

When I try to add a new source in Channels, a network scan does not locate the HD Homerun box.

It was working perfectly until I unplugged it to set up the new TV.

To be fair, I've been sick and have "medicine brain" so I'm sure there's some simple step I am just missing.

Help and advise would be appreciated!

[Edwin_Perez]

HDHomeRun not found (HDHomeRun software):
Symptom: Only the Power LED lit on the HDHomeRun.
Power cycle the HDHomeRun. Check that the LEDs flash through a sequence.
If the LEDs do not flash through a sequence when power cycled then file a trouble ticket.
If the LEDs flash through a sequence when power cycled then the HDHomeRun is working
but is not getting Ethernet link. Try a different Ethernet cable and a different port on the
router or switch. Verify that the router is configured to assigned addresses via DHCP and
that it is not restricted to specific devices.
Symptom: Ethernet LED flashing, connected to network.
The HDHomeRun is attempting to obtain a DHCP lease. In most cases, the DHCP response
is provided by a home cable or DSL router – check the router is functioning correctly or
power cycle the router.
As of the 20080427 firmware the HDHomeRun can be reached by an AutoIP address
without the need for DHCP, however the network LED will still flash until it receives a
command from the driver or HDHomeRun Setup software